IBM Netfinity 7100, Руководство по установке

Страница: 23 / 60

Chapter 2. Installing options
13
Installing a microprocessor
Your server comes with one microprocessor installed in connector J2. This is the
startup (boot) microprocessor. A microprocessor installed in connector J3 is
microprocessor 2; a microprocessor installed in connector J4 is microprocessor 3; a
microprocessor installed in connector J5 is processor 4. If more than one
microprocessor is installed, the highest numbered microprocessor is the one the server
will start from. The lower numbered microprocessors are used as application
microprocessors.
The illustrations in this document might differ slightly from your hardware.
Attention:
When you handle Electrostatic Discharge-Sensitive devices (ESD), take
precautions to avoid damage from static electricity. For details on handling these
devices, refer to the following Web site and use a search term of ESD:
http://www.ibm.com/
To install an additional microprocessor kit:
1. Review the information in “Safety” on page v.
2. Turn off the server and remove the power cords.
3. Remove the top cover.
4. Remove the processor housing cover.
5. Remove the terminator card from the connector.
6. Install the microprocessor.
Note:
Each microprocessor connector must contain either a terminator card or a
microprocessor.
7. Install the voltage regulator module (VRM).
8. Install the processor housing cover.
9. Install the top cover.
10. Cable the server and connect all power cords.
Pop rivets
Terminator card
VRM
Processor housing
cover