IBM Netfinity 7100, Руководство по установке

Страница: 22 / 60

12
IBM® Netfinity® 7600 Installation Guide
Installing a drive in a hot-swap bay
Your server supports ten 1-inch (26 mm) slim-high or seven 1.6-inch (42 mm) half-
high, 3.5-inch hot-swap hard disk drives in the hot-swap bays.
Note: See the User’s Reference on the IBM Netfinity Documentation CD for
information on installing devices in the non-hot-swap bays.
The illustrations in this document might differ slightly from your hardware.
Attention:
When you handle Electrostatic Discharge-Sensitive devices (ESD), take
precautions to avoid damage from static electricity. For details on handling these
devices, refer to the following Web site and use a search term of ESD:
http://www.ibm.com/
To install a drive in a hot-swap bay:
1. Review the information in “Safety” on page v.
2. Remove the filler panel.
3. Place the drive handle in the open position and slide the drive into the bay.
4. Close the drive handle.
5. If there is a gap above or below the drive, remove the slim filler from the filler
panel and install it above or below the drive.
Slim filler
Filler panel
Drive tray handle
(in open position)