IBM N3400, Инструкции по установке и настройке

Страница: 9 / 30

DANGER
To avoid hazardous conditions due to uneven mechanical loading, always install the heaviest
devices in the bottom of the rack cabinet. Always install servers and optional devices starting from
the bottom of the rack cabinet. (R001 part 1 of 2)
v
When installing storage expansion units in a rack, do not exceed the maximum storage limit for your
system.
v
Make sure that the ID on the back panel of each storage expansion unit matches the ID specified on its
label.
v
Always install the storage expansion units fully loaded. Do not remove disk drives to reduce the
weight.
1. Loosen (but do not remove) the four rail adjustment screws on each rail. See Figure 2.
2. Refer to Figure 3 on page 4. At the front of the rack, position the right-hand rail into the rack at the
appropriate EIA location. Make sure that the two locating pins seat properly in holes H3 and H4. The
bottom of the rail should line up with the bottom EIA boundary.
Right rail
Left rail
Front of rack
Rear of rack
Rail adjustment
screws
Locating pins
n620007
Figure 2. Installing the rails
Installation and setup instructions
3