IBM N3400, Инструкции по установке и настройке

Страница: 28 / 30

b. Enter
5
to select the Onboard FC-AL test menu.
c.
Enter
72
at the prompt to show attached FC-AL devices.
d. Exit the Diagnostic Monitor by entering
99
at the prompt. Enter the
exit
command to return to
LOADER. Start Data ONTAP by entering
autoboot
at the prompt
10. If your system does not boot successfully, it might not have the boot image downloaded on the boot
device. Call IBM Service and Support at 1-800-IBM-SERV (1-800-426-7378).
Additional resources
The following sources provide additional information about the N3400.
For more information about... Refer to the following IBM System Storage N series document
New features, enhancements, known issues,
and late-breaking news for your version of
Data ONTAP software The Release Notes for your version of Data ONTAP
Setting up and verifying software
configuration Data ONTAP Software Setup Guide
Configuring and managing the iSCSI or FC
protocol, and creating and managing LUNs
and initiator groups with the iSCSI or FC
service Data ONTAP Block Access Management Guide for iSCSI and FCP
Cabling, configuring, and disk ownership Data ONTAP Active/Active Configuration Guide
Data ONTAP High Availability Configuration Guide
Data ONTAP System Administration Guide
Data ONTAP Data Protection Guides
Testing field-replaceable units and diagnosing
and correcting system hardware problems Diagnostics Guide
Hardware configuration options for your
system Introduction and Planning Guide
N3300, N3400, and N3600 Hardware and Service Guide
Troubleshooting the system Platform Monitoring Guide
Configuring your remote management port
after initial setup Data ONTAP System Administration Guide
Safety information Safety Notices
The IBM System Storage N series support website contains additional information about N series
hardware and software products:
www.ibm.com/storage/support/nseries
22