IBM IntelliStation A Pro 6224, Руководство по техническому обслуживанию и ремонту, Страница: 99 / 172

Diagnostic error codes
Note: In the following error codes, if XXX is 000, 195, or 197, do not replace a
FRU. The description for these error codes are:
000 The test passed.
195 The Esc key was pressed to stop the test.
197 Warning; a hardware failure did not occur. The test could not be run due to
some other problem.
For all error codes, replace the FRU or take the action indicated.
Note: See Chapter 7, “Parts listing, Type 6224,” on page 107 to determine which components are replaceable by the
customer (CRU), and which components must be replaced by a field service technician (FRU).
Error code/symptom FRU/action
001-250-000
(Failed system board ECC)
v System board
001-250-001
(Failed system board ECC)
v
System board
001-XXX-000
(Failed core tests)
v
System board
001-XXX-001
(Failed core tests)
v System board
005-XXX-000
(Failed video test)
1. Video adapter (if installed)
2. System board
011-XXX-000
(Failed COM1 serial port test)
1. Check loopback plug connected to externalized serial port.
2. Check cable from externalized port to system board.
3. System board.
011-XXX-001
(Failed COM2 serial port test)
1. Check loopback plug connected to externalized serial port.
2. Check cable from externalized port to system board.
3. System board.
014-XXX-000
(Failed parallel port test)
v
System board
015-XXX-001
(USB interface not found, board damaged)
1. System board
015-XXX-015
(Failed USB external loopback test)
1. Make sure the parallel port is not disabled.
2. Run the USB external loopback test again.
3. System board.
015-XXX-198 (Remote Supervisor Adapter
II installed or USB device connected during
USB test)
1. If Remote Supervisor Adapter II is installed as an option,
remove it and rerun test.
Note: If Remote Supervisor Adapter II is present as a standard
installation, do not remove it; the test cannot be run.
2. Remove USB devices and rerun test.
3. System board.
020-XXX-000
(Failed PCI interface test)
v
System board
030-XXX-00N
(Failed SCSI interface test)
v If N=0, system board; if N>0, SCSI adapter in slot N.
Chapter 6. Symptom-to-FRU index
89