IBM IntelliStation A Pro 6224, Руководство по техническому обслуживанию и ремонту

Страница: 49 / 172

Replacing a drive in bay 3
Note: Only a 3.5-in. SCSI device can be installed in bay 3.
Complete the following steps to install a drive in bay 3:
1. Read the safety information in Appendix B, “Safety information,” on page 117,
the guidelines in “Handling static-sensitive devices” on page 25, and the
documentation that comes with the drive.
2. Make sure that you have all the cables and other equipment specified in the
documentation that comes with the drive.
3. Check the instructions that come with the drive to determine whether you need
to set any switches or jumpers on the drive. Make sure that you set the SCSI
ID for that device.
4. Turn off the computer and all attached devices; then, disconnect all external
cables and power cords.
5. Remove the side cover (see “Replacing the side cover” on page 27).
6. Remove the front bezel (see “Replacing the bezel” on page 30).
7. Remove the support bracket (see “Replacing the support bracket” on page 29).
8. Rotate the drive cage up.
9. If the bay is empty, use a screwdriver to pry the filler panel and EMC shield
away from the computer.
10. If the bay contains a drive, remove it:
a. If the drive is secured with screws, remove the screws and set them in a
safe place.
b. If the drive is secured with a tooless clip, remove it and set it aside to
install on the new drive.
Note: If you are installing a drive that contains a laser, review the following
safety precaution.
Chapter 4. Customer replaceable units
39