IBM Infoprint 1130, Руководство по обслуживанию

Страница: 43 / 433

2-16
Service Manual
IBM Infoprint 1130/1140
89 xx 0D The fuser exit sensor bounced. Check the exit sensor for
correct operation. Check the fuser DC cable to J14 on the
system board. Also, the system board may be failing.
8D 00 00 The fuser exit sensor was never activated by the leading
edge of the media fed through the printer.
*This error can be displayed after a 201 paper jam.
*This can be caused by a defective fuser exit sensor
assembly.
Enter the diagnostic tests menu, select base sensor tests,
select output sensor test and check the fuser exit sensor for
correct operation. If the test fails, check the internal fuser
cabling, DC autoconnect on the fuser frame, fuser DC
autoconnect to the system board cable, and the cable
connection to J14 on the system board.
8E xx 02 x1
x2 This error can be caused by the input sensor not being
activated by a page that was known to have been picked by a
source other than the duplex option.
*Ensure the correct source has been selected and the media
is feeding from that source.
8E xx 06 x1 The second pick failed from a paper source when paper was
in the source and the only sheet in the paper path.
8E xx 07 x1 The second pick failed from a paper source when paper was
in the source. Other sheets may have started to feed, but
none were in the paper path.
8E xx 08 The paper in the output bin was flushed. The paper ahead of
it, in the paper path, never made it past the output bin sensor
or into the tray.
8E xx 09 x1 The second pick from the MPT, Tray 1 or feeder failed when
paper was in the source. Other sheets may be in the paper
path.
(x1=Media Source)
8E xx 0A x1 The second pick from the MPT, Tray 1 or feeder failed when
paper was in the source. Other sheets may have started to
pick, but none were in the paper path.
x1=Media Source)
First 6
Bytes Sub
Error Code
Data - Note:
xx can be
any value.
Explanation