IBM HS40 - BladeCenter - 8839, Руководство по установке

Страница: 17 / 64

1) In the navigation pane, click I/O Module Tasks
→
Configuration .
2)
Scroll to the Bay 1 (Ethernet SM)* section.
3) Set the values in the New Static IP Configuration fields, if they are not
already correct as listed in the Current IP Configuration section. The
values must be in the following formats:
v
IP address: x.x.x.x
v Subnet mask: x.x.x.x
v
Gateway address: x.x.x.x
The static IP configuration values specify valid IP addresses of the form
x.x.x.x , where each x is a number from 0 to 255.
4) If you changed any values, click Save .
5.
Complete the following steps to restart the management module. Restarting the
management module ends the current BladeCenter management-module Web
interface session.
a. In the navigation pane, click MM Control
→
Restart MM .
b. Click Restart .
c. Click OK to confirm.
d. Click Yes to restart the management module and end the session.
Installing and configuring SSH for SOL
Complete the following steps to install and configure Secure Shell Server (SSH) for
SOL:
1.
Start the BladeCenter management-module Web interface (see “Starting the
BladeCenter management-module Web interface” on page 5).
2. If you have not previously installed a security key file, complete the following
steps. Otherwise, go to step 3.
a. In the navigation pane, click MM Control
→
Security .
b. Download the latest version of the SSH security key file from
http://www.ibm.com/support/. Navigate to the
Install SSL/SSH section
and click BladeCenter firmware update .
c. Click Browse and select the file that was downloaded in step 2b.
d.
Click
Install SSL/SSH
.
e. Scroll to the Install SSL/SSH section and click Configure and enable .
3.
Complete the following steps to generate the SSH Server Private Key:
a. In the navigation pane, click MM Control
→
Security .
b. Scroll to the SSH Server Key Management section and click Generate SSH
Server Private Key .
c. Click OK to confirm.
4. Complete the following steps to enable SSH:
a. Scroll to the Secure Shell (SSH) Server section.
b. Select Enabled for the SSH Server option; then, click Save .
c.
Click
OK
to confirm.
5. Complete the following steps to restart the management module. Restarting the
management module ends the current BladeCenter management-module Web
interface session.
a.
In the navigation pane, click MM Control
→
Restart MM .
b. Click Restart .
Chapter 2. General configuration
11