IBM HS40 - BladeCenter - 8839, Руководство по установке

Страница: 25 / 64

Modified /boot/grub/grub.conf contents
#grub.conf generated by anaconda
#
# Note that you do not have to rerun grub after making changes to this file
# NOTICE: You have a /boot partition. This means that
# all kernel and initrd paths are relative to /boot/, eg.
# root (hd0,0)
# kernel /vmlinuz-version ro root=/dev/hda6
# initrd /initrd-version.img
#boot=/dev/hda
default=0
timeout=10
# splashimage=(hd0,0)/grub/splash.xpm.gz
# This will allow you to only Monitor the OS boot via SOL
title Red Hat Enterprise Linux ES (2.4.9-e.12smp) SOL Monitor
root (hd0,0)
kernel /vmlinuz-2.4.9-e.12smp ro root=/dev/hda6 console=ttyS1,19200 console=tty1
initrd /initrd-2.4.9-e.12smp.img
# This will allow you to Interact with the OS boot via SOL
title Red Hat Linux (2.4.9-e.12smp) SOL Interactive
root (hd0,0)
kernel /vmlinuz-2.4.9-e.12smp ro root=/dev/hda6 console=tty1 console=ttyS1,19200
initrd /initrd-2.4.9-e.12smp.img
title Red Hat Enterprise Linux ES-up (2.4.9-e.12)
root (hd0,0)
kernel /vmlinuz-2.4.9-e.12 ro root=/dev/hda6
initrd /initrd-2.4.9-e.12.img
You must reboot the Linux operating system after completing these procedures for
the changes to take effect and to enable SOL. You must also install device drivers
for your Ethernet controller (see “Installing the Ethernet controller device driver
for Linux operating systems” on page 21).
SUSE SLES 8.0 configuration
Note: This procedure is based on a default installation of SUSE SLES 8.0. The file
names, structures, and commands might be different for other versions of SUSE
Linux.
Complete the following steps to configure the general Linux parameters for SOL
operation when using the SUSE SLES 8.0 operating system.
Note:
Hardware flow control prevents character loss during communication over a
serial connection. You must enable it when using a Linux operating system.
1. Add the following line to the end of the
# getty-programs for the normal
runlevels
section of the /etc/inittab file. This enables hardware flow control
and enables users to log in through the SOL console.
7:2345:respawn:/sbin/agetty -h ttyS1 19200 vt102
Chapter 3. Operating system configuration
19