IBM H Series, Инструкция по установке и обслуживанию

Страница: 147 / 438

Table 3-1 (Page 38 of 40). Firmware Error Codes.
Error Code Description Action / Possible Failing FRU
4B201000 Checkstop 1. Attempt to reboot the system in
Service Mode, this preserves the AIX
error log. If the reboot fails, attempt to
reboot from the CD-ROM. If the
reboot is successful, run Diagnostics
in Problem Determination mode to
determine the cause of the failure.
Otherwise continue.
2. CPU card.
3. System board.
4. PCI adapter.
5. I/O board (See notes on 3-1.)
4B201020 TEA Error Refer to “MAP 1540: Minimum
Configuration” on page 2-37.
4BA00000 The system support controller
detects the service processor, but
cannot establish communication.
The system halts 1. Replace the service processor (Model
H50 only).
2. Replace the I/O board. (See notes on
3-1.)
4BA00001 The system support controller
cannot detect the service processor. 1. Replace the service processor (Model
H50 only).
2. Replace the I/O board. (See notes on
3-1.)
4BA00800 Unknown error Check level of Service Processor, if not
the latest and problem persist, call for
support.
4BA00826 Service processor cannot call home Replace the I/O board (See notes on
3-1.)
4BA00827 Flash update floppy/diskette fail 1. Put image on another diskette and
re-try.
2. Replace the floppy drive.
4BA00828 Flash update (crc) checksum fail Replace the flash image.
4BA00829 Bad system firmware. Replace I/O board (See notes on 3-1.)
4BA00830 Boot fail See “Boot Problems and Concerns” on
page 3-65.
Chapter 3. Error Code to FRU Index
3-39