IBM H Series, Инструкция по установке и обслуживанию

Страница: 141 / 438

Table 3-1 (Page 32 of 40). Firmware Error Codes.
Error Code Description Action / Possible Failing FRU
40D00101 Bist on I/O board failed I/O board (See notes on 3-1.)
40D00102 BIST on system board fail System board.
45800000 Memory controller checkstop 1. System board.
2. If problem is not resolved continue to
“Step 1540-25” on page 2-61.
45B00001 A non-compatible memory card is
detected Replace the memory card, as indicated by
the physical location code, with a compat-
ible memory card supported by this
system.
45C00000 Memory checkstop. (Uncorrectable
memory error.) 1. Attempt to reboot the system in
Service Mode. This preserves the AIX
error log. If the reboot fails, attempt to
reboot from the CD-ROM. If the reboot
is successful, run Diagnostics in
Problem Determination mode to deter-
mine the cause of the failure.
2. System board.
48800909 System vpd error 1. Check cable to op-panel
2. Replace op-panel
3. I/O board (See notes on 3-1.)
4880090A Generic vpd error Refer to “Step 1540-25” on page 2-61.
4880090B Error identifying system type using
vpd 1. I 2 C bus error.
2. Call for support.
4880090C Jtag unable to confirm system type
using system vpd 1. Remove cards.
2. Verify part numbers.
3. Install valid cards.
4. Call for support.
Chapter 3. Error Code to FRU Index
3-33