b. Carefully grasp the adapter by its top edge or upper corners, and align it
with the expansion slot on the system board.
Attention:
When you install an adapter in the server, be sure that it is
completely and correctly seated in the system-board connector. Incomplete
insertion might cause damage to the system board or the adapter.
c. Press the adapter
firmly
into the expansion slot.
d. Lower the adapter-retention latch over the top corner of the adapter. The
adapter-retention latch automatically locks into place.
Important:
Power cannot be restored to the adapter slot if the latch is not
lowered into place.
12. If you installed a full-length adapter, close the adapter-retention clip on the
adapter-support bracket. Otherwise, continue with the next step.
Attention:
When you route the cables, do not block the ventilated space
around any of the fans.
13. Connect any needed cables to the adapter.
14. Enable the hot-plug PCI-X slot from your operating system. When the hot-plug
PCI-X slot is enabled, the power LED for that hot-plug PCI-X slot comes on.
See the documentation that comes with your operating system for information
about enabling a hot-plug PCI-X slot.
15. If you have other options to install or remove, do so now; otherwise, go to
“Installing the server bezel and left-side cover (tower model)” on page 62 or
“Installing the server bezel and top cover (rack configuration)” on page 65.
Chapter 2. Installing options
25
Содержание eServer xSeries 235 Type 8671
