IBM eServer 380 xSeries, Руководство по установке

Страница: 25 / 54

Chapter 2. Installing options
11
The following illustration shows the installation of a hot-swap power-supply:
Complete the following steps to replace a hot-swap power supply:
1. Review the information in “Before you begin” on page 3.
2. Press the handle-locking tab to the left, and pull the power-supply handle down.
3. Slide the power-supply out of the server.
4. Remove the new power-supply from the protective packaging, and place it on a
static-protective surface.
5. With the handle in the open position (pulled down), slide the power supply into the
power-supply bay.
6. Push the handle up and into the locked position.
7. Check the power-supply status indicators to verify the power supply is functioning
properly.
Power supply handle
Handle locking tab