IBM E16RMLL-I - Tivoli Storage Manager, Руководство по внедрению

Страница: 694 / 828

664
IBM Tivoli Storage Manager Implementation Guide
11.Set any attributes appropriate to your network interface and network
environment.
12.Type
X
to return to the Remote Initial Program Load menu.
13.Select Test Ping.
14.Input the appropriate IP information to ping the pluto partition.
15.Type X two times to return to the main SMS menu.
16.Type
X
to exit SMS and start the network boot process.
The partition boots to the SysBack Installation and Maintenance Main Menu.
Sample install from remote tape
After your partition has booted to the SysBack Installation and Maintenance Main
Menu you must change the installation device to point to mars (install server)
using the following steps:
1. Select Change Installation Device.
2. Select the desired network interface.
3. Enter the client and server IP addresses, client gateway, and subnet mask for
mars.
4. Press Esc to return to the main menu.
5. Select Change Volume Group & Logical Volume Information.
6. Select the appropriate DVD device on the remote system from the Select
Source for Volume Group Data menu.
Note: If your client and server are on the same subnet (the client does not
require a gateway to get to the server), specify the server address again for
the client_gateway variable.
Note: This new partition may not have as many disk drives assigned to it
as the source partition. The disk drives may also be of a different size. You
may want to enable mirroring in this partition when it did not exist on the
source partition. These changes, and many more, can be used to
customize this installation. For more information about how to change LVM
information, refer to Chapter 11, “Changing the Volume Group, Logical
Volume, and File system Attributes,” in the IBM Tivoli Storage Manager for
System Backup and Recovery Installation and User’s Guide, available at:
http://publib.boulder.ibm.com/infocenter/tivihelp/v1r1/index.jsp?topic=/c
om.ibm.itsmsbr.doc/bmrug565.htm