IBM E16RMLL-I - Tivoli Storage Manager, Руководство по внедрению

Страница: 686 / 828

656
IBM Tivoli Storage Manager Implementation Guide
10.Select Adapter Parameters.
11.Set any attributes appropriate to you network interface and network
environment.
12.Type X to return to the Remote Initial Program Load menu.
13.Select Test Ping.
14.Input the appropriate IP information to ping the mars partition.
15.Type
X
two times to return to the main SMS menu.
16.Type X to exit SMS and start the network boot process.
The partition boots to the SysBack Installation and Maintenance Main Menu.
Sample install from remote tape
After your partition has booted to the SysBack Installation and Maintenance
Main Menu, and if you want to install over the same network interface from
which you booted, execute only steps 5 to 10 below. However, if you want to
install from a different network interface, you must change to it and configure the
desired network interface, as follows.
To install from a remote tape, do the following steps:
1. Select Change Installation Device.
2. Select the desired network interface.
3. Enter the client IP address, server IP address, client gateway, and subnet
mask in order to use this interface.
4. Press Esc to return to the main menu.
5. Select Change Volume Group & Logical Volume Information.
6. Select the appropriate tape device on the remote system from the Select
Source for Volume Group Data menu.
7. Tape processing occurs to position the tape to the correct location.
8. Press Esc to return to the main menu.
9. Select Install the System with Current Settings to begin the installation.
10.The install proceeds without any further intervention. Once completed, the
system login prompt opens.
Note: If your client and server are on the same subnet (the client does not
require a gateway to get to the server), specify the server address again for
the client_gateway variable.