IBM CS821, Руководство по обслуживанию

Страница: 100 / 118

CAUTION:
v The chassis rails only extend about half of the distance of the chassis. Once the safety latches
are released, the chassis only slides forward a few inches before disengaging from the rails. Be
prepared to support the full weight of the chassis as you remove it from the slide rails.
v The chassis contains most of the weight in the back side of the unit. When you remove the
system, take care to be ready to support the weight by grasping the chassis closer to the back of
the unit.
4. Using two people, release the rail safety latches and remove the system from the rails. The safety
latches work in opposite directions; the latch on one side moves up while the latch on the other side
moves down.
5. Carefully set the system on a table with an appropriate ESD surface.
Placing an 8001-12C system into the operating position
Learn how to place an IBM Power System S821LC (8001-12C) system into the operating position.
About this task
CAUTION:
or or
The weight of this part or unit is between 18 and 32 kg (39.7 and 70.5 lb). It takes two persons to
safely lift this part or unit. (C009)
Procedure
1. Using two people, one on each side of the system, lift the system from the table.
2. Align the system rails on each side of the system with the rack slide rails.
3. Push the system into the rack until you hear each rail click into place.
4. Before releasing your hold on the system, ensure that the rails are engaged by sliding the system
forward into service lock position. Check that the rails are properly seated. If the rails are not fully
engaged, the system could drop.
5. Release the rail safety latches (A), as shown in Figure 85 on page 85, then push the system fully into
the rack. The safety latches work in opposite directions; the latch on one side moves up while the
latch on the other side moves down.
84
Power Systems: Servicing the IBM Power System S821LC (8001-12C) or the IBM CS821 (8005-12N)