IBM BladeCenter QS20, Руководство по диагностике и обслуживанию

Страница: 77 / 100

1. Read the safety information beginning on page vii and “Installation guidelines”
on page 39.
2. Connect the control-panel cable to the control-panel connector on the
system-board assembly.
3. Connect the serial cable from the serial connector to the serial connector on the
system-board assembly.
4. Carefully slide the bezel assembly onto the blade server as shown in the
illustration, until it clicks into place.
Note:
v If InfiniBand is installed, partially insert the side fins of the bezel into the
metal guides while ensuring that the top of the bezel rests on the foam
gasket on the InfiniBand card.
v
Make sure the serial cable, routed along the inside and across the bottom
of the bezel, is housed underneath the blade’s board.
Chapter 5. Installing and removing replaceable units
59