IBM BladeCenter QS20, Руководство по диагностике и обслуживанию

Страница: 37 / 100

Welcome to Open Firmware
Copyright International Business Machines Corporation 2004 – 2006
US Government Users Restricted Rights -- Use, duplication or
disclosure restricted by GSA ADP Schedule Contract with IBM Corp.
Cell BE is a trademark of SONY Computer Entertainment Inc.
Type ’boot’ and press return to continue booting the system.
Type ’reset-all’ and press enter to reboot the system.
Supported boot media
The BladeCenter QS20 can boot either from its local hard disk drive or from the
network subject to the following restrictions:
v
Locally attached ATA hard disk drive
– Only yaboot is supported and must be installed on the Master Boot Record
– Use the Management Module set the boot list to
Disk0
.
v Standard Bootp/TFTP network boot
– Only the built-in Gigabit Ethernet Controller of I/O Bridge is supported
– Only boot through the Ethernet switch on the top side of BladeCenter
– No fall back or configurable change to the bottom switch is possible
– Supported switch vendors are: Dlink, Nortel, and Cisco
– In the Management Module you need to set boot list to “Network”
– There is no support for a router between the blade and TFTP server. Only
local TFTP is supported.
Configure the required boot mode using the Management Module. See IBM
BladeCenter Management Module Installation Guide for more information.
Chapter 2. Diagnostics and troubleshooting
19