IBM BladeCenter HS22V, Инструкция по установке и эксплуатации

Страница: 57 / 108

6. Locate the CIOv expansion connector (see “Blade server connectors” on page
18).
Retaining
clips
Expansion
card
7. Using your fingers, move the retaining clips away from the CIOv card; then, lift
the card out of the connector.
Installing a storage interface card
Use this information to install a storage interface card in the blade server.
The storage interface card controls the SAS storage drives. The following
illustrations and installation instructions show how to install a ServeRAID-MR10ie
controller into the CIOv expansion connector of the blade server. The illustrations
and installation instructions are similar for other CIOv storage interface cards.
Note:
The backup-battery will be installed in DIMM connector ten and might
affect how much memory is recognized by the blade server. Review the tables in
“Installing a memory module” on page 29 to make sure that your memory
configuration will not be affected.
ServeRAID
controller
Cable "B "
To install a storage interface card, complete the following steps.
1.
Before you begin, read “Safety” on page v and “Installation guidelines” on
page 19.
Chapter 3. Installing options
41