IBM BladeCenter HS22V, Инструкция по установке и эксплуатации

Страница: 54 / 108

9. Firmly press on the indicated locations to seat the expansion card.
Note: For device-driver and configuration information to complete the
installation of the expansion card, see the documentation that comes with the
expansion card.
10. If you have other devices to install or remove, do so now; otherwise, go to
“Completing the installation” on page 49.
Removing a horizontal-combination-form-factor expansion
card
Use these instructions to remove a horizontal-combination-form-factor expansion
card from the blade server.
The following illustration shows how to remove a horizontal-compact-form-factor
(CFFh) expansion card.
Blade
expansion
connector
cover
Expansion
card
Expansion
card
standoff
Release
lever
To remove a CFFh expansion card, complete the following steps:
1. Before you begin, read “Safety” on page v and “Installation guidelines” on
page 19.
2.
If the blade server is installed in a BladeCenter unit, remove it (see “Removing
the blade server from the BladeCenter unit” on page 21 for instructions).
3. Carefully lay the blade server on a flat, static-protective surface.
4.
Open the blade server cover (see “Removing the blade server cover” on page
22 for instructions).
5. Locate the CFFh expansion card. The CFFh is installed into the blade expansion
connector (see “Blade server connectors” on page 18).
6. Locate the release lever on the CFFh expansion card; then, use your finger to
lift up on the release lever to loosen the expansion card from the expansion
connector.
7. Use your fingers to hold the edge of the CFFh expansion card where it
connects to the blade expansion connector; then, lift up on the card.
8. Pull the card away from the expansion-card standoff.
38
BladeCenter HS22V Type 7871 and 1949: Installation and User's Guide