IBM BladeCenter HS22V 1949, Руководство по диагностике и обслуживанию

Страница: 97 / 258

2. Touch the static-protective package that contains the storage interface card to
any
unpainted metal surface on the BladeCenter unit or any unpainted metal
surface on any other grounded rack component; then, remove the storage
interface card from the package.
3. If an interposer card is installed on the storage interface card, remove it.
a.
If the interposer has a pull strap, move the pull strap away from the
storage interface card. If the pull strap surrounds the storage interface
card, the pull strap will interfere with the removal of the interposer card.
b. Press out on the plastic latch that holds the interposer card to the storage
interface card and simultaneously lift up on the controller, as shown.
c. Separate the interposer card from the storage interface card and store the
interposer card in a safe place.
4.
Install the backup-battery cable to the storage interface card.
a. If you are installing a ServeRAID-MR10ie controller, select cable "B" from
the packaging.
b.
Locate the end of the cable marked “EXPANSION CARD”; then, with the
blue side of the cable end facing up, carefully insert the cable end into the
cable connector on the ServeRAID controller.
ServeRAID
controller
Cable "B "
5.
Orient the connector on the storage interface card with the CIOv expansion
connector on the system board; then, press the storage interface card into the
CIOv expansion connector.
6. Firmly press on the indicated locations to seat the storage interface card.
Chapter 5. Removing and replacing blade server components
81