IBM BladeCenter HS20, Инструкция по установке и эксплуатации

Страница: 47 / 88

Installing the blade server bezel assembly
The following illustration shows how to install the blade server bezel assembly.
Control panel
connector
Bezel-assembly
release
Bezel-assembly
release
Control-panel
cable
To install the blade server bezel assembly, complete the following steps:
1. Read the safety information beginning on page v and “Installation guidelines” on
page 21.
2. Connect the control-panel cable to the control-panel connector on the system
board.
3. Carefully slide the bezel assembly onto the blade server until it clicks into place.
Closing the blade server cover
Important: The blade server cannot be inserted into the BladeCenter unit until the
cover is installed and closed or an expansion unit is installed. Do not attempt to
override this protection.
The following illustration shows how to close the blade server cover.
Blade-Cover
Release
Cover
Pins
Blade-Cover
Release
To close the blade server cover, complete the following steps:
1. Read the safety information beginning on page v and “Installation guidelines” on
page 21.
2. If you removed the blade bezel assembly, replace it now (see “Installing the
blade server bezel assembly” for instructions).
3. Lower the cover so that the slots at the rear slide down onto the pins at the rear
of the blade server, as shown in the illustration. Before closing the cover, check
Chapter 3. Installing options
35