IBM BladeCenter HS20, Инструкция по установке и эксплуатации

Страница: 35 / 88

2. Open the two release handles as shown in the illustration. The blade server
moves out of the bay approximately 0.6 cm (0.25 inch).
3. Pull the blade server out of the bay. Spring-loaded doors further back in the bay
move into place to cover the bay temporarily.
4. Place either a filler blade or another blade in the bay within 1 minute. The
recessed spring-loaded doors will move out of the way as you insert the blade
or filler blade.
Opening the blade server cover
The following illustration shows how to open the cover on a blade server.
Blade-Cover
Release
Cover
Pins
Blade-Cover
Release
To open the blade server cover, complete the following steps:
1. Read the safety information beginning on page v and “Installation guidelines” on
page 21.
2. If the blade server is installed in a BladeCenter unit, remove it (see “Removing
the blade server from the BladeCenter unit” on page 22 for instructions).
3. Carefully lay the blade server down on a flat, non-conductive surface, with the
cover side up.
4. Press the blade-cover release on each side of the blade server and lift the
cover open, as shown in the illustration.
5. Lay the cover flat, or lift it from the blade server and store for future use.
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.
Chapter 3. Installing options
23