IBM @Server pSeries 630 6E4, Руководство по обслуживанию

Страница: 309 / 651

Table 5. Service Processor Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
406B 0EB6 Attention line 5 stuck fault Go to “MAP 1540: Problem Isolation Procedures”
on page 124.
406B 0EB7 Attention line 6 stuck fault Go to “MAP 1540: Problem Isolation Procedures”
on page 124.
406B 0EB8 Attention line 7 stuck fault Go to “MAP 1540: Problem Isolation Procedures”
on page 124.
406B 0EB9 Attention line 8 stuck fault Go to “MAP 1540: Problem Isolation Procedures”
on page 124.
406B 0EBA Attention line 9 stuck fault Go to “MAP 1540: Problem Isolation Procedures”
on page 124.
406B 0EBB Attention line 10 stuck fault Go to “MAP 1540: Problem Isolation Procedures”
on page 124.
406B 0EBC Attention line 11 stuck fault Go to “MAP 1540: Problem Isolation Procedures”
on page 124.
406B 0EBF Description: Memory error
Action:
1. Reboot the system in slow mode to the SMS menus. See “Performing Slow Boot” on page 209.
2. Examine the service processor error log.
v If a CEC subsystem error (a 4xxx yyyy error) occurred during the slow boot that calls out the
memory, processors, L3 cache modules or the primary I/O book, replace the part indicated
by the location code.
v
If a CEC subsystem error (a 4xxx yyyy error) did not occur during the slow boot, look for a
4xxx yyyy error immediately preceding the 406B 0EBF error. Replace the part indicated by
the location code associated with that error.
406B 0EE1 Service processor firmware: invalid MRU to FRU
mapping
1. Check for system firmware updates.
2. Call service support.
406B 0EE2 Service processor firmware fault
1. Check for system firmware updates.
2. Call service support.
406B 0EE5 Firmware error, no callout available
1. Check for system firmware updates.
2. Call service support.
406C 0001 Scan interface basic assurance tests detected a
CEC backplane fault
CEC backplane
Location: U0.1-P1
406C 0002 CEC backplane fault
1. Check JTAG cable connections
2. CEC backplane
Location: U0.1-P1
406C 0003 Scan interface basic assurance tests detected
processor fault
1. Check JTAG cable connections.
2. Processor card
Location: U0.1-P1-C1
406C 0004 Processor fault
1. Check JTAG cable connections.
2. Processor card
Location: U0.1-P1-C2
406C 000E Processor capacity card Operator Panel
Location: U0.1-L1
Chapter 5. Error Code to FRU Index
289