IBM 9006-22C, Установка и настройка

Страница: 103 / 148

Form factor
Short, low-profile
Attributes provided
Samsung 3rd-generation TLC V-NAND technology
Five drive writes per day (DWPD)
Delivers a wide bandwidth of up to 6,400/3,000 MB/s sequential R/W speeds respectively
Operating system or partition requirements
If you are installing a new feature, ensure that you have the software that is required to support the new
feature and that you determine whether any prerequisites must be met for this feature and attaching
devices. To check for operating system and partition requirements, see one of the following links:
• The latest version of enabling libraries and utilities can be downloaded from Fix Central (http://
www.ibm.com/support/fixcentral/).
• IBM Prerequisite website (www14.software.ibm.com/support/customercare/iprt/home).
• IBM SSIC (System Storage Interoperation Center) (http://www-03.ibm.com/systems/support/storage/
ssic/interoperability.wss).
• The latest version of the device driver or the IBM Power RAID adapter utilities (iprutils) can be
downloaded from the IBM Service and Productivity Tools website (http://www14.software.ibm.com/
webapp/set2/sas/f/lopdiags/home.html).
• For more information, see the Linux Alert website (www14.software.ibm.com/webapp/set2/sas/f/
lopdiags/info/LinuxAlerts.html).
Installing a PCIe adapter in the 9006-22P system
Complete the steps in this procedure to install a PCIe adapter in the IBM Power System LC922
(9006-22P) system.
Before you begin
Power off the system and place it in the service position. For instructions, see “Preparing the 5104-22C,
9006-22C, or 9006-22P system to remove and replace internal parts” on page 105.
Procedure
1. Attach the electrostatic discharge (ESD) wrist strap.
The ESD wrist strap must be connected to an unpainted metal surface until the service procedure is
completed, and if applicable, until the service access cover is replaced.
Attention:
• Attach an electrostatic discharge (ESD) wrist strap to the front ESD jack, to the rear ESD jack,
or to an unpainted metal surface of your hardware to prevent the electrostatic discharge from
damaging your hardware.
• When you use an ESD wrist strap, follow all electrical safety procedures. An ESD wrist strap is
used for static control. It does not increase or decrease your risk of receiving electric shock
when using or working on electrical equipment.
• If you do not have an ESD wrist strap, just prior to removing the product from ESD packaging
and installing or replacing hardware, touch an unpainted metal surface of the system for a
minimum of 5 seconds. If at any point in this service process you move away from the system,
it is important to again discharge yourself by touching an unpainted metal surface for at least
5 seconds before you continue with the service process.
2. An adapter can share a PCIe riser card with other adapters. Label and remove any cables and plugs
that extend out of the adapters.
Installing and configuring your system and system features 89