IBM 8863 - eServer xSeries 366, Руководство по установке

Страница: 61 / 94

Chapter 6. Solving problems
This chapter provides basic troubleshooting information to help you solve some
common problems that might occur while you are setting up the server.
If you cannot locate and correct the problem using the information in this chapter,
see “Getting help and technical assistance,” on page 67, the Problem Determination
and Service Guide on the IBM xSeries Documentation CD, and the “Server
Support” flowchart in the front of this document.
Diagnostic tools overview
The following tools are available to help you diagnose and solve hardware-related
problems:
v
POST beep codes
The power-on self-test beep codes indicate the detection of a problem.
– One beep indicates successful completion of POST, with no errors.
– More than one beep indicates that POST detected a problem. Error messages
also appear during startup if POST detects a hardware-configuration problem.
See “POST beep codes,” and the Problem Determination and Service Guide
on the IBM xSeries Documentation CD for more information.
v
Troubleshooting charts
These charts list problem symptoms and steps to correct the problems. See
“Troubleshooting charts” on page 53 for more information.
v
Diagnostic programs and error messages
The system diagnostic programs are provided in ROM. These programs test the
major components of the server. See the Problem Determination and Service
Guide on the IBM xSeries Documentation CD for more information.
v Light path diagnostics
Use light path diagnostics to diagnose system errors quickly. See “Light path
diagnostics” on page 60 for more information.
POST beep codes
POST emits one beep to signal successful completion. If POST detects a problem
during startup, other beep codes might occur. Use the following beep code
descriptions to help diagnose and solve problems that are detected during startup.
Note: See the Problem Determination and Service Guide on the IBM xSeries
Documentation CD for more information about the POST beep codes.
One beep
POST was completed successfully without finding any errors.
Two short beeps
The server configuration has changed.
Other beep codes
See the Problem Determination and Service Guide on the IBM xSeries
Documentation CD for more information about the POST beep codes.
© Copyright IBM Corp. 2005
49