IBM 88625RX, Руководство по установке

Страница: 25 / 104

Note: The following illustration shows installing DIMMs in an 8-DIMM-connector
memory board.
DIMM 2
DIMM 6
DIMM 1
DIMM 5
DIMM connector 6
DIMM connector 2
Retaining clips
5. Insert the DIMM into the connector.
6. If you have other options to install or remove, do so now; otherwise, go to
“Completing the installation” on page 26.
Installing a hot-swap hard disk drive
The following notes describe the types of hard disk drives that your server supports
and other information that you must consider when installing a hard disk drive:
v
The server supports up to six 26 mm (1-inch), 3.5-inch, hot-swap hard disk drives
in the hot-swap bays.
v Each hot-swap drive is in a tray, which has a green activity LED and an amber
status LED in the upper-right corner. The activity LED flashes when the drive is
active; the status LED is lit if the drive has an error. Each hot-swap drive has a
single-connector-attached (SCA) connector, which connects directly into the
hot-swap SCSI hard disk drive backplane. The backplane controls the SCSI IDs
for the hot-swap drives.
v Before you install a hot-swap hard disk drive, take the following actions:
– Inspect the drive tray for any signs of damage.
– Make sure that the drive is installed in the tray correctly.
– If your server has an optional RAID adapter installed, see the documentation
that comes with the adapter for information about installing a hard disk drive.
Complete the following steps to install a hard disk drive:
1. Review the safety information beginning on page v, and “Installation guidelines”
on page 7.
Chapter 2. Installing options
13