IBM 88625RX, Руководство по установке

Страница: 26 / 104

2. Remove the filler panel and air baffle from one of the empty hot-swap bays, if
present.
Attention: To maintain proper system cooling, do not operate the server for
more than 10 minutes without either a drive or a filler panel and air baffle
installed in each bay.
Filler panel
Drive-tray assembly
Drive handle
(in open position)
Air baffle
3. Install the hard disk drive in the hot-swap bay.
4. If you have other options to install or remove, do so now; otherwise, go to
“Completing the installation” on page 26.
Note: If the server has a RAID controller or adapter installed, you might need
to reconfigure the disk arrays after installing hard disk drives. See the
documentation that comes with the adapter for more information.
Installing a PCI or PCI-X adapter
Attention: The Remote Supervisor Adapter II, which is in PCI slot 1, is not
hot-pluggable . Turn off the server before removing or replacing the Remote
Supervisor Adapter II.
The following notes describe the types of adapters that your server supports and
other information that you must consider when installing a PCI or PCI-X adapter:
v
The server supports 3.3 V and universal PCI and PCI-X adapters; it does not
support 5.0-V-only adapters.
v The following illustration shows the location and bus speeds of the PCI-X
expansion slots on the I/O board.
14
xSeries 365 Type 8861 and 8862: Installation Guide