IBM 883725U, Руководство по установке

Страница: 29 / 114

Attention:
v Do not use excessive force when pressing the microprocessor into the
socket.
v
Center the microprocessor over the microprocessor socket. Align the
triangle on the corner of the microprocessor with the triangle on the
corner of the socket and carefully press the microprocessor into the
socket before you try to close the lever.
Microprocessor
orientation indicator
Microprocessor-
release lever
Microprocessor
connector
Microprocessor
7. Close the microprocessor-release lever to secure the microprocessor.
Attention:
v
Do not set the heat sink down after you remove the plastic cover.
v
Do not touch or contaminate the thermal grease on the bottom of the new
heat sink. Doing so damages its heat-conducting capability and exposes the
new microprocessor to overheating.
v
If you must remove the heat sink after installing it, note that the thermal
grease might have formed a strong bond between the heat sink and the
microprocessor. Do not force the heat sink and microprocessor apart; doing
so can damage the microprocessor pins. Loosen one captive screw fully
before loosening the other captive screw to help break the bond between
the components without damaging them.
8. Remove the cover from the bottom of the heat sink and make sure that the
thermal grease is still on the bottom of the heat sink.
9. Install the heat sink on top of the microprocessor, and tighten the captive
screws. Alternate between the screws until they are tight, making sure that you
do not overtighten them.
Chapter 2. Installing options
17