IBM 8668 - Eserver xSeries 232, Руководство по техническому обслуживанию аппаратной части

Страница: 76 / 182

Filler panel
Cable-restraint
bracket
Power supply
backplane option
Power supply
Power supply handle
(in open position)
To install a hot-swap power supply:
1. Remove the filler panel from the empty power supply bay by inserting your
finger into the depression on the filler panel and pulling it away from the
server. Save the filler panel in case you remove the power supply at a later
time.
Note:
During typical operation, each power-supply bay must have either a
power supply or filler panel installed for proper cooling.
2. Install the power supply in the bay:
a.
Place the handle on the power supply in the open position (that is,
perpendicular to the power supply) and slide the power supply into the
chassis.
b. Gently close the handle to seat the power supply in the bay.
3. Plug the power cord for the added power supply into the power cord
connector.
4. Route the power cord through the cable-restraint bracket.
5. Plug the power cord into a properly grounded electrical outlet.
6.
Verify that the dc power light and ac power light on the power supply are lit,
indicating that the power supply is operating correctly.
7. If you have other options to install or remove, do so now.
Removing a hot-swap power supply
If you have a hot-swap power-supply backplane and have installed power
supplies, you normally have power redundancy and hot-swappability. However, if
the load on your server requires the capacity of all installed power supplies, you
do not have redundancy or hot-swappability and must turn off the server before
removing any of your power supplies.
Attention: If you do not have power redundancy, and you remove a power
supply while the system is running, your system will immediately stop working.
Adding a power supply
68
Hardware Maintenance Manual: Type 8668