IBM 8668 - Eserver xSeries 232, Руководство по техническому обслуживанию аппаратной части

Страница: 68 / 182

6. Refer to the documentation provided with the option to complete the
installation of the option. (See “SCSI connector pin-number assignments” on
page 93 for locations of the cable connectors on the system board.)
7.
If you have other options to install or remove, do so now; otherwise, go to
“Installing the bezel and front door” on page 80.
Installing memory modules
Adding memory to your server is an easy way to make programs run faster. You
can increase the amount of memory in your server by installing options called
memory-module kits . Each kit contains one industry-standard, dual inline memory
module (DIMM). Your server supports a two-way interleaved memory
configuration. You must install matched pairs of memory kits. The set in slots 1
and 4 do not need to be the same size as the set in slots 2 and 3.
Notes:
1.
Your server comes with two dual inline memory modules (DIMM) installed in
DIMM connectors 1 and 4. Install additional DIMMs as instructed in the
documentation that comes with your option.
2. Your xSeries 232 server supports 128 MB, 256 MB, 512 MB, and 1 GB DIMMs.
You must install the DIMMs in pairs of the same size. Place pair 1 in slots 1
and 4 and pair 2 in slots 2 and 3. Refer to the ServerProven
®
list on the World
Wide Web at http://www.ibm.com/pc/compat for information about memory
modules for use with your server.
3. Installing or removing DIMMs changes the configuration information in the
server. Therefore, after installing or removing a DIMM, you must save the new
configuration information in the Configuration/Setup Utility program. When
you restart the server, the system displays a message indicating that the
memory configuration has changed. Start the Configuration/Setup Utility
program and select
Save Settings.
Installing a hot-swap expansion kit
60
Hardware Maintenance Manual: Type 8668