IBM 84885BU, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 68 / 200

Statement 2
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has a
module containing a lithium battery, replace it only with the same module type made
by the same manufacturer. The battery contains lithium and can explode if not
properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v
Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Complete the following steps to replace the battery:
1. Read Appendix B, “Safety information,” on page 143, and “Installation
guidelines” on page 25.
2. Follow any special handling and installation instructions supplied with the
replacement battery.
3. Turn off the server and all attached devices.
4. Disconnect all power cords; then, disconnect all external cables.
5. Remove the side cover (see “Removing the side cover” on page 28).
6. Remove the frame-support bracket (see “Removing and installing the support
bracket” on page 32).
7. Remove any adapters that impede access to the battery.
8. Remove the battery:
a. Use a fingernail to press the top of the battery clip away from the battery.
The battery pops up when released.
b. Use your thumb and index finger to lift the battery from the socket.
9. Insert the new battery:
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
b. Press the battery down into the socket until it clicks into place. Make sure
the battery clip holds the battery securely.
58
xSeries 226 Type 8488 and 8648: Hardware Maintenance Manual and Troubleshooting Guide