IBM 84885BU, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 41 / 200

Replacing the bezel
Complete the following steps to replace the bezel.
Openings
Hooks
Tab
Bezel
Release
tab
Note: For hot-swap hard disk drive models, make sure the side cover is unlocked;
then, slide the lock bar on the bezel to the left (unlocked) before you begin.
1. Insert the tab on the left side of the bezel into the matching hole on the chassis
left front.
2. Slide the bezel toward the bottom of the server until you can insert the two
openings on the bottom rear of the bezel onto the matching hooks on the server
chassis.
3. Push the top of the bezel toward the server until the two tabs at the top of the
bezel snap into place.
4. For hot-swap hard disk drive models, slide the lock bar to the right. The
hot-swap lock bar locks when you lock the side cover key lock.
5. Lock the side cover.
Chapter 4. Customer replacement units
31