IBM 8480 - Eserver xSeries 205, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 72 / 174

Video connector
Your server uses a graphics controller located on the PCI extender card. The video
connector is located on the rear of your server. See “System board external
connectors” on page 36 for the location of this connector.
1 5
11 15
Some models come with a digital video interface (DVI) connector for connecting a
digital monitor.
1 C1 C2
C3
C5
C4
Keyboard connector
Your server has one keyboard connector. See “System board external connectors”
on page 36 for the location of this connector.
Note: If you attach a standard (non-USB) keyboard to the keyboard connector, the
USB ports and devices are disabled during the power-on self-test (POST).
6
4
2 1
3
5
Mouse connector
Your server has one mouse connector that supports a mouse or other pointing
device. The mouse connector is located on the rear of your computer. See “System
board external connectors” on page 36 for the location of this connector.
6
4
2
1
3
5
Parallel connector
Your server has one 25-pin, female D-shell parallel connector. This connector
supports three standard Institute of Electrical and Electronics Engineers (IEEE)
1284 modes of operation: standard parallel port (SPP), enhanced parallel port
(EPP), and extended capability port (ECP). See “System board external connectors”
on page 36 for the location of this connector.
13 1
25 14
Use the Configuration/Setup Utility program to configure the parallel connector as
bidirectional. With this configuration, data can be read from and written to a device.
In bidirectional mode, the server supports the ECP and EPP modes.
62
IBM xSeries 205 Type 8480: Hardware Maintenance Manual and Troubleshooting Guide