IBM 7220, Инструкция по эксплуатации

Страница: 91 / 155

6-15
Chapter 6, COMPUTER OPERATION
17 10 s
18 20 s
19 50 s
20 100 s
21 200 s
22 500 s
23 1 ks
24 2 ks
25 5 ks
The TC. command is only used for reading the time constant, and reports the current
setting in seconds. Hence if a TC 11 command were sent, TC would report 11 and
TC. would report 1.0E-01, i.e. 0.1 s or 100 ms.
SYNC [n] Synchronous time constant control
At reference frequencies below 10 Hz, if the synchronous time constant is enabled,
then the actual time constant of the output filters is not generally the selected value T
but rather a value equal to an integer number of reference cycles. If T is greater than
1 cycle, the time constant is between T/2 and T. The parameter n has the following
significance:
n Effect
0 Synchronous time constant disabled
1 Synchronous time constant enabled
6.4.04 Signal Channel Output Amplifiers
XOF [n
1
[n
2
]] X output offset control
The value of n
1
sets the status of the X offset facility according to the following table:
n
1
Selection
0 Disables offset facility
1 Enables offset facility
The range of n
2
is ±30000 corresponding to ±300 % full-scale.
YOF [n
1
[n
2
]] Y output offset control
The value of n
1
sets the status of the Y offset facility according to the following table:
n
1
Selection
0 Disables offset facility
1 Enables offset facility
The range of n
2
is ±30000 corresponding to ±300 % full-scale.