IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal..., Руководство пользователя

Страница: 179 / 236

Enable PDF417 truncation
RS-232 Syntax:
GS T n or X'1D;54;n'
where:
n Whether to enable truncation.
0 = Disable truncation.
1 = Enable truncation.
Default:
n = 0
Remarks:
Truncated PDF generates a symbol with the right row indicator and stop
pattern replaced by a single width bar. There is a slight degradation in
decode performance if truncation is enabled, which allows more data to fit
in the image width.
Print character commands
These commands should be sent after ASCII data is sent to the printer and is being
held in the print buffer. Any of these commands will increment the line count by 1.
(See “Status byte 6” on page 167 and “Reset line count” on page 162.)
Print and line feed
RS-232 Syntax:
LF or X'0A'
Purpose:
Prints data in the print buffer and feeds the paper by a preset amount.
Print and line feed
RS-232 Syntax:
CR or X'0D'
Purpose:
Prints data in the print buffer and feeds the paper by a preset amount.
Remarks:
There is an MCT to enable or disable this command. The default is to
disable or ignore the CR command.
Print, form feed, and cut the paper (FF)
RS-232 Syntax:
FF or X'0C'
Purpose:
Prints data in the print buffer and feeds the paper in the customer receipt
(CR) station or document insert (DI) station by a preset amount, until the
document exits the feed rollers. If a cutter is available at the station (CR
station only), it cuts the paper.
August 24, 2004
Appendix C. RS-232 programming information
151
|
|
|
|