IBM 4610-TM6 - SureMark Printer TM6 Two-color Thermal..., Руководство пользователя

Страница: 143 / 236

v
“Print predefined graphics (logo) command” on page 154 can be included
in this command.
v The size of all predefined messages cannot exceed 8000 bytes.
Example:
Store a trailer message:
X'1D3A01'
’Thank You For Shopping’ X'0D'
’ At RSD STORE’ X'0D'
’Store #1234567’ X'0D'
X'1D3A'
This would store this message as predefined message 1. See “Print
predefined messages” on page 155 for printing this trailer message.
Commands for selecting the print station and print characteristics must be
included with the stored message.
Limitations:
v
“Print predefined graphics (logo) command” on page 154 can be included
in this command. Select and print a graphics command cannot be used.
See “Print graphic messages” on page 152.
v “Print predefined messages” on page 155 can be included in this
command, but can only be nested one message deep.
Example: Store a predefined message (’Jane Doe’) at location 3, then
issue the following commands:
1. X'1D3A06'
2. ’Welcome to Our Store’ X'0D'
3. X'1D5E03' (This prints the message that has been stored at location
3. The message cannot have a X'1D5Exx' in it, because that would
be more than one level of nesting.)
4. ’Is Your Cashier Today’ X'0D'
5. X'1D3A'
Using the stored message and the above commands, the resulting text
will be:
Welcome to Our Store
Jane Doe Is Your Cashier Today
v These commands cannot be included in the predefined message:
– “Define document wait time” on page 138.
– “Select character for reprinted lines” on page 139.
– “Set sheet eject length” on page 135.
– “Select and print a graphics (logo) command” on page 152.
v This command should be sent only when the data buffer is empty. See
the description of bit 6 in “Status byte 2” on page 166.
Error Conditions:
Flash EPROM load error - Verify the sector was erased before downloading
the messages.
Memory sector is full - This sector can store up 8 KB of message data.
After that the sector is full.
August 24, 2004
Appendix C. RS-232 programming information
115