IBM 300GL Type 6275, Руководство пользователя

Страница: 139 / 208

POST Message Description
1883
1884 A Plug and Play adapter has requested a memory address that is not
available, or the Plug and Play adapter might be defective.
Action:
1. Make sure that settings for all ISA legacy adapters are correct in the
Configuration/Setup Utility program. If the memory address settings
are not correct, change and save the settings. Setting the resources
used by ISA legacy adapters to ISA Resource enables the Plug and
Play function to configure around the legacy adapters.
For background information on PCI, ISA, Plug and Play, and legacy
(non-Plug and Play) adapters, refer to Installing Options in Your Personal
Computer. For information about required memory resource settings
for ISA legacy adapters, refer to the documentation that comes with
these adapters. For instructions on using the Configuration/Setup
Utility program, see Chapter 5, “Using the Configuration/Setup Utility
program” on page 61.
2. Make sure that switches on all ISA legacy adapters are set correctly.
For information about switch settings, refer to the documentation that
comes with the ISA legacy adapters.
3. If all memory addresses are being used by ISA legacy adapters, you
might need to remove an ISA legacy adapter to make a memory
address available to the Plug and Play adapter you want to install. For
instructions on removing adapters, see Installing Options in Your
Personal Computer.
Note:
If you remove an ISA legacy adapter, set the memory address
used by the removed adapter to Available before installing
another adapter.
4. If you have other PCI or Plug and Play adapters installed, you might
need to remove one of these adapters to make a memory address
available to the Plug and Play adapter you want to install.
5. If your system will be loading a Plug and Play operating system,
ensure that Plug and Play Operating System is set to Yes.
6. Ensure that the address decode value for the adapter is properly set.
If the problem cannot be isolated and corrected, have the computer
serviced.
1885 A Plug and Play adapter read-only memory (ROM) error occurred.
Action: Remove all of the Plug and Play adapters that are not required for
system startup and reinstall them one at a time, retesting after each is
reinstalled. When an adapter fails, replace it.
If the problem cannot be isolated and corrected, have the computer
serviced.
Chapter 7. Solving problems
121