IBM 2073-700, Быстрое руководство по установке

Страница: 29 / 82

3.
Note: If you are installing the slide rails into a 1U space with devices already
installed directly above and below this 1U space, you need to extend the slide
rails to slide the rear of the slide rails into the rear of the rack. When installing
a 2U device, be sure to install the slide rails in the bottom positon of the 2U
area in the rack.
From the front of the rack, line up the two pins on the rear of the slide rail in
the selected unit on the rear of the rack. Push the rails so that the pins go into
the holes and slide the rails into the rack to lock the rear of the slide rails into
the rack.
4. Push the blue button to allow the latch to slide forward. Then pull the slide rail
forward and locate the front latch in the appropriate unit space in front of the
rack EIA rail. Adjust the length of the rail.
ifs00021
Figure 18. Open the rear slide rail hooks.
ifs00022
Figure 19. Install the rear end of the slide rails.
Chapter 2. Performing the hardware installation
19