IBM 10/100 EtherJet CardBus Adapter with 56K Modem, Инструкция по установке и эксплуатации

Страница: 40 / 67

4-4 10/100 EtherJet CardBus Adapter with 56K Modem
• Try loading the CardBus drivers at different memory locations
(i.e.: C800, CC00, D400, D800).
• Try using different interrupt locations (i.e.: 5, 10, 11).
• Try using different port addresses (i.e.: 280, 290, 310, 320).
Keyword Reference (All Drivers)
CABLEDETECT turns the automatic cable detect feature on or
off. When on, cable detect senses when there is no LAN cable
attached to the card, and puts the adapter into a low-power
mode. Normal power is restored when the cable is reattached.
CACHE sets system cache line size on the CardBus bridge. Val-
ues are system dependent and may include only 0 (cache dis-
abled), 4, 8, 16, or 32. Changes could affect network
performance.
DIRECTENABLE (32-bit NDIS3 Driver IBMC.SYS) forces
method used by driver to determine if a EtherJet CardBus
Adapter with 56K Modem is present. Valid parameters are Auto-
Detect, Off, and On. AutoDetect allows the driver to determine if
the CardBus bridge has already been set up by another enabler
such as Socket and Card Services. If so, the driver uses the cur-
rent configuration. On forces the driver to enable the CardBus
bridge without checking its current state.
DRIVERNAME=IBM$ required as first item in the IBM section of
the PROTOCOL.INI file for the IBMCNDIS driver.
EARLYRECEIVE see NOEARLYRX.
EARLYTRANSMIT see NOEARLYTX.
ERT specifies Advanced Look-ahead Pipelining threshold. Valid
settings are LOW, MEDIUM, and HIGH. Changing this value will
affects network performance, depending on the computer sys-
tem.
INT, INTERRUPTNUMBER see IRQ.
INTERRUPTSTYLE (For 32-bit NDIS3 Driver IBMC.SYS only)
forces the driver to use ISA IRQ routing or PCI IRQ routing. Some
CardBus bridges have the capability of supporting both PCI and
ISA style IRQ routing. Valid parameters are AutoDetect, PCI-IRQ,
and ISA-IRQ. The default keyword is AutoDetect.
fcr0mst.book Page 4 Monday, July 13, 1998 9:36 AM