IBM 10/100 EtherJet CardBus Adapter with 56K Modem, Инструкция по установке и эксплуатации

Страница: 38 / 67

4-2 10/100 EtherJet CardBus Adapter with 56K Modem
1. Install the EtherJet CardBus Adapter with 56K Modem
according to the instructions contained in Chapter 1, “Hard-
ware Installation”.
2. Power down and restart the computer from MS-DOS. DO
NOT load a network driver.
3. Run the diagnostic test by typing IBMCTEST at the MS-DOS
prompt, then press Enter.
Note: Do not run IBMCTEST with a network driver loaded. Load-
ing a network driver before running
IBMC
TEST may cause
unpredictable results when exiting the test utility.
Main Screen
The program consists of several function buttons and a view
pane. Pressing or invoking a function brings up the correspond-
ing screen in the view pane. This view remains until another is
selected. To exit IBMCTEST type x or push the Exit button.
When a function is active, the button appears to remain down or
pushed. Once the button pops up, the function is completed and
the screen is a passive results display.
Nine functions can be invoked by pushing the associated button
on the main screen, using the highlighted letter indicated on the
button, or the left mouse button. Online help is provided.
Note: Write down the EtherJet CardBus Adapter with 56K
Modem model and serial numbers for reference.
Executing the Windows 95, 98, and NT
Diagnostic Program
1. Verify that the EtherJet CardBus Adapter with 56K Modem
has been installed and configured to work in your version of
Windows.
2. Insert the Windows 95, 98, and NT Network Drivers Diskette
in the diskette drive.
3. Select Start, Run, a:\ejetdiag.exe.
4. Navigate through the diagnostic program by clicking the
appropriate tab. When finished, click OK to exit.
fcr0mst.book Page 2 Monday, July 13, 1998 9:36 AM