![background image](http://html.mh-extra.com/html/ibc-water/as1041mp-cl/as1041mp-cl_installation-and-operating-instructions-manual_605211015.webp)
AS1041MP-CL
Page
15
Installation
All plumbing and electrical connections must conform
to local codes. Inspect the unit carefully for carrier
shortage or shipping damage.
Location Selection
•
Locate unit as close to a drain as possible
•
If supplementary water treating equipment is
required, make sure that adequate additional
space is available. Locate the cabinet softener in
an accessible place so that salt can easily be
added.
•
Do not install any unit closer than 3m (10ft) of
piping between the outlet of the water conditioner
and the inlet of the water heater. Water heaters
can transmit heat back down the cold water pipe
into the control valve. Hot water can severely
damage the controller.
A 3m total pipe run (including bends, elbows etc) is a
reasonable distance to prevent hot water damage. A
positive way to prevent hot water from flowing from a
heat source to the conditioner is to install a check
valve in the soft water piping from the conditioner. If a
check valve is installed, make sure that the water-
heating unit is equipped with a properly rated
temperature and pressure safety relief valve. Always
conform to local codes.
•
Do not locate the unit in an area where the temp
ever falls below 1ºC (34ºF) or over 49ºC (120ºF).
•
Do not install the unit near acid or acid fumes.
•
Do not expose the unit to petroleum products.
Water Line Connection
A bypass valve system must be installed to provide
for occasions when the water conditioner must is by-
passed for hard water or for servicing. Bypass offers
simplicity and ease of operation. These softeners are
equipped as standard with a bypass valve. See pages
14 and15
Drain Line Connection – to sewer
Figure 3 – Typical Illustration of a Bypass
Содержание AS1041MP-CL
