IBC Water AS1029MP-CL, Инструкция по установке и эксплуатации

Страница: 46 / 55

AS1029MP-CL Page
46
Compliance Table
Application Injector and/or
Plug(s)
Main
Piston
Regenerant
Piston
Stack Body
WS1EI Downflow Softener or
Regenerating Filter Injector in “DN” hole. V3011 V3174 V3005 V3001
Refill Flow Control Assembly or Refill Port Plug
To clean or replace the refill flow control, pull out the elbow-locking clip and then pull straight up on the elbow.
Replace the elbow locking clip in the slot so that it is not misplaced. Twist to remove the white flow control
retainer. The flow control can be removed by prying upward through the side slots of the retainer with a small
flat blade screwdriver.
Chemically clean the flow control or the white flow control retainer using vinegar. Do not use a wire brush. If
necessary, replace the flow control, o-ring on the flow control retainer, or the o-ring on the elbow.
Reseat the flow control so the rounded end is visible in the flow control. Reseat the white flow control retainer
by pushing the retainer into the elbow until the o-ring seats. Remove locking clip, push down on elbow to
reseat and insert locking clip.
Do not use Vaseline, oils, or other unacceptable lubricants on o-rings. A silicone lubricant may be used on the
o-ring on the elbow or the white retainer.
Water Meter or Meter Plug
The water meter assembly is connected to the PC board by a cable. If the entire water meter assembly is to be
replaced, remove the control valve cover and disconnect the power source and water meter plugs from the PC
board. Unlatch the drive assembly and lean it forward. Unthread the water meter wire from the side of the
drive assembly and through the drive back plate. To reinstall, rethread the water meter wire through the drive
back plate and the side of the drive assembly. Reattach the drive assembly and the water meter and power
plugs.
If no water meter wire is visible, then a plug is installed, not a water meter.
The water meter cable does not need to be removed from the PC board if the water meter is only being
inspected and cleaned. To remove the water meter assembly, unscrew the meter cap on the left side of the
control valve. Pliers may be used to unscrew the nut if necessary.
With the nut removed, a slot at the top of the water meter is visible. Twist a flat blade screwdriver in the slot
between the control valve body and the meter. When the meter is part way out it is easy to remove the water
meter from the housing. Once the water meter is removed from the control valve body, gently pull forward on
the turbine to remove it from the shaft.
Do not use a wire brush to clean the turbine. Wipe with a clean cloth or chemically clean in vinegar. The
turbine can be immersed in the vinegar. Do not immerse electronics. If the turbine is scored or damaged or
the bearings on the turbine are worn, replace the turbine.
Do not lubricate the turbine shaft. The turbine shaft bearings are pre-lubricated. Do not use Vaseline, oils, or
other unacceptable lubricants on the o-ring. A silicone lubricant may be used on the black o-ring.
Snap the turbine on the shaft and reinsert the water meter into the side slot. Hand tighten the nut. Do not use a
pipe wrench to tighten nut.