Initialize one at a time. It is OK to initialize either the PTZ part or the multi part
first.
9. Other
9.1
Initialize
Press the INITIAL SET button to initialize the main unit. See below for the position of the
INITIAL SET button.
(1) Disconnect the Ethernet cable from the computer and turn off the computer.
(2) Turn on the computer while pressing the [INITIAL SET] button.
(3) [INITIAL SET] button holds pressing for 15 seconds or more after power is turned on
(4) Release the [INITIAL SET] button
・
Approximately two minutes later, the computer is started and the settings containing the
network settings are initialized. If it does not start normally, try again.
9.2
About 802.1X of this unit
When using the 802.1X function, use a switch that allows multiple supplicants to connect to a
single port. For details, refer to the following.
Our technical information website (C0141)
9.3
Check the software version
The functions of this machine are implemented in software. We recommend that you first check
the current software version if there is a problem with the operation of the computer.
9. Other
9.3 Check the software version
38
