6.3.3.2.
When the switch lever is released, a brake is automatically activated that slows and
stops chain movement, in order to prevent the risk of injury should the chain continue to
turn after it has been switched off?
6.3.3.3.
In the event of a kickback while working, following an irregular contact of the tip of
the bar, with a brusque upward movement that causes the hand to strike the front
guard. In this case, the brake blocks chain movement and must be released manually in
order to disengage it.
6.3.3.4.
This brake can be operated manually by pushing the front guard forward. To release
the brake, pull the front guard towards the handgrip until you hear a click.
6.3.3.5.
To check that the brake works efficiently proceed as follows;
6.3.3.6.
Start the engine by holding the front handgrip and push the front hand guard
forwards with your thumb (towards the bar).
6.3.3.7.
When the brake is engaged, release the trigger switch.
6.3.3.8.
The chain must stop as soon as the brake is engaged.
6.3.4.
Chain lubricant.
6.3.4.1.
It is essential that you use good quality oil to lubricate the cutting parts effectively.
6.3.4.2.
Used or poor quality oil does not guarantee good lubrication and reduces the
duration of the chain and bar.
6.4.
Charging the battery.
6.4.1.
Remove the battery from the machine,
Only use chain-saw oil or adhesive oil for chain-saws. Do not use oil containing
impurities, to avoid clogging the tank filter and permanently damaging the oiler.
The chain lubricating oil is bio-degradable. The use of mineral oil or engine oil can
have a serious impact on the environment.
Before each machine use, the oil level should be checked and topped up to 1 cm
from the rim of the filler. The oil level must not drop below the «MIN» level mark.
Check that the socket mains voltage is the same as that indicated on the battery
charger plate.
Page 12
Rev 2
Содержание HYC36LI
Страница 1: ......
