6.10.
Directions for use.
6.10.1.
Before felling or de-limbing for the first time, practise sawing logs on the ground or on
trestles, so that you can get familiar with the machine and the most suitable sawing
techniques.
6.11.
End of work.
6.11.1.
Switch OFF the machine please follow
6.4.2. Stopping the machine (Fig 3).
6.11.2.
Wait for the chain to stop and allow the machine to cool.
6.11.3.
Remove any traces of sawdust or oil deposits from the chain.
6.11.4.
If there is excessive dirt or resin build-up, disassemble the chain and place it in a container
with a specific cleanser. Then rinse it with clean water and treat it with a suitable anticorrosive
spray, before reassembling on the machine.
6.11.5.
Fit the bar cover before reassembling the machine.
Always hold the machine with both hands when sawing.
Stop the motor immediately if the chain stops during sawing. Beware of kickback,
which can occur if the bar contacts an obstacle.
Be careful of where the branches are lying on the ground, the risk of them being
under tension, the direction the branch may go during cutting and the risk of the
tree being unstable after the branch has been cut.
Allow the motor to cool before storing in any enclosure.
To reduce fire hazards, clean the machine thoroughly to get rid of any remains of
grass, leaves or excess grease, never leave containers with the cut debris inside the
storage area.
Page 16
Rev 2
Содержание HYC36LI
Страница 1: ......
