Hyundai Coupe Tiburon 2007, Руководство пользователя, Страница: 407 / 487

3
IN CASE OF EMERGENCY
9
D060F01MC
Wheel nut wrench
SD070G1-E
5. Raising the Car
After inserting a wrench bar into the
wheel nut wrench, install the wrench
bar into the jack as shown in the draw-
ing. As the jack begins to raise the
vehicle, double check that it is properly
positioned and will not slip. If the jack
is on soft ground or sand, it may be
necessary to place a stout piece of
timber under the base of the jack to
prevent it from sinking.
Raise the car high enough so that the
fully inflated spare tyre can be in-
stalled.
Wrench bar
!
WARNING:
Do not get under the car when it is
supported by the jack! The jack is
solely designed for wheel chang-
ing and is not intended to support
the vehicle for other purposes. The
use of purpose designed supports
is necessary whilst the vehicle is
raised and the operator is required
to get underneath.
Loosen the wheel nuts and remove
them with your fingers. slide the wheel
off the studs and lay it flat so it cannot
roll away. To put the wheel on the hub,
pick up the spare tyre, line up the holes
with the studs and slide the wheel onto
them. If this is difficult, tip the wheel
slightly and get the top hole in the
wheel lined up with the top stud. Then
jiggle the wheel back and forth until the
wheel can be slid over the other studs.
OGK036403
D060G02Y-EAT
6. Changing Wheels