Hyundai Coupe Tiburon 2007, Руководство пользователя

Страница: 173 / 487

3
WHAT TO DO IN AN EMERGENCY
8
HGK4013
D060D02A-AAT
3. Loosen Wheel Nuts
The wheel nuts should be loosened
slightly before raising the car. To loosen
the nuts, turn the wrench handle coun-
terclockwise. When doing this, be sure
that the socket is seated completely
over the nut so it cannot slip off. For
maximum leverage, position the
wrench so the handle is to the left as
shown in the drawing. Then, while
holding the wrench near the end of the
handle, push down on it with steady
pressure. Do not remove the nuts at
this time. Just loosen them about one-
half turn.
D060E01A-AAT
4. Put the Jack in Place
The base of the jack should be placed
on firm, level ground. The jack should
be positioned as shown in the drawing.
D060F02E-AAT
5. Raising the Car
After inserting a bar into the wheel nut
wrench, install the bar into the jack as
shown in the drawing. To raise the
vehicle, turn the jack handle clock-
wise. As the jack begins to raise the
vehicle, double check that it is properly
positioned and will not slip. If the jack
is on soft ground or sand, place a
board, brick, flat stone or other object
under the base of the jack to keep it
from sinking.
Raise the car high enough so that the
fully inflated spare tire can be installed.
To do this, you will need more ground
clearance than is required to remove
the flat tire.
Wrench bar
OGK036401 D060F01MC
Wheel nut
wrench