Hyundai power products HYRM1000, Инструкция по эксплуатации

Страница: 34 / 48

34
Diagnostics
Check Signal
Home Screen > Diagnostics > Check Signal
You can check the boundary signal status.
Signals include:
1. L sensor (to check if mower inside the
boundary wire area or outer).
2.
R sensor (shows if mower inside the
boundary wire area or outer).
3.
Lift sensor (to check if the lift sensor is ok).
4.
Bump sensor (to check if the bumper
sensor is ok).
5.
Rain sensor (to check if the rain sensor is
ok).
NOTE -
For signals 1-2, the words ‘None’ or ‘Inner’ or
‘Outer’ will appear on the screen.
None - Means the signal sensor is broken.
Inner - Means the signal sensor is ok.
Outer - Means no signal.
For signals 3-5, the words ‘OK’ or ‘NG’ will
show on the screen.
OK - Means sensor is normal.
NG - Means sensor is not good.
Mowing Motor Test
Home Screen > Diagnostics > Test Start
Mowing Motor
ATTENTION -
Before you test the mowing
motor, we must make sure there is no
obstacle at the bottom of the machine. Press
the ‘OK’ button, then the screen shows
‘Please input
7 to test’, and follow the
instruction press ‘ 7 ’ button, the mowing motor
will work and check if it is normal or not.
Test Wheel Motor
This is to check whether the wheel is working
normal.
ATTENTION - Before you test the wheel
motor, you must make sure to put the
machine in an open area, in order to prevent
the machine from running around, causing
losses. Press ‘OK’ button, then the screen
shows ‘Please input
7 to test’, and follow the
instruction press ‘ 7 ’ button, the wheel motor
will work and check if it is normal or not.
Test Startpoint
You can check whether the lawn mower can
reach each start points according to settings.
Home Screen > Diagnostics > Test
Startpoints > Point 1 to > Point 3
You can test if the lawn mower will correctly
go to the specific startpoint.
NOTE -
Perform this test when the lawn mower is
connected to the docking station.