Hyundai power products HYRM1000, Инструкция по эксплуатации

Страница: 32 / 48

32
Lawn Setup
Set Spiral Cutting
Home Screen > Lawn Setup > Auto Mode
Setting > Spiral Cutting
After setting this function, the lawn mower
could focus on mowing the area where the
lawn is not completely mown or where the
grass is too thick.
Manual Mode Setting
Please refer to the auto mode setting and
repeat the steps as above. In manual mode,
you can manually move your mower to
other zones which has buried boundary wire
for mowing. In this mode, you need to
manually move the mower for cutting and
recharging.
Operating In Auto Mode
When turning the lawn mower, you must enter
the PIN.
AUTO Mode Operation
These instructions can be used to operate the
lawn mower at the time scheduled and
startpoint settled for the auto mode settings.
Make sure to press the STOP button before
performing the following procedure:
Operating In Manual Mode
When turning the lawn mower, you must enter
the PIN.
STEP 1
Enter the PIN using the number buttons.
Press the OK button. The home screen is
displayed AUTO.
STEP 2
Setup completed. If the lawn mower is on
the charging station when you complete the
above setting, the lawn mower will start
mowing at the time scheduled and startpoint
for AUTO mode. If the lawn mower inside the
signal area, the robot will start to work
automatically.
STEP 1
Press the OK button.
STEP 2
If the (Auto) is displayed on the home screen,
go to step 3.
If the (Man) is displayed on the home screen,
press the HOME button and select (Auto) by
arrow button, then press OK button.
STEP 3
Press start button, then press OK button,
finally close the control panel cover to start
mowing.
STEP 4
STEP 1
Enter the PIN using the number buttons.
STEP 2
Press the OK button.
The home screen is displayed Man.